Durden has developed a high degree of skill in processing a large variety of high heat, filled and blend engineered resins. This coupled with our ability to produce tight tolerance, short lead time, and short to long production runs, offers an ideal solution for our customers to manager their lead times and inventories while assuring top quality parts. 

Durden offers a full range of molding processes to include; insert molding, over molding, and gas assist molding on parts that vary in size from 1 gram to 1.5 lbs.

As seen in these picture we run a wide variety of geometries,
material and applications of injection molded parts.

Molding Room:

1- 28 Ton 1.3 oz. Arburg Injection Press
1- 40 Ton 4 oz. Arbrug Injection Press
1- 66 Ton 5 oz. Arburg Injection Press
2- 77 Ton 4.7 oz. Arburg Injection Presses
1- 85 Ton 5 oz. JSW Injection Press
1- 90 Ton 5 oz. Mitsubishi Injection Press
1- 180 Ton 18 oz. Mitsubishi Injection Press
1- 210 Ton 30 oz. Mitsubishi Injection Press
1- 250 Ton 28 oz. Mitsubishi Injection Press
1- Gain Gas Assist Machine
7- Material Dryers
3- Oil Heaters
2- Thermolators

Above are shown examples of parts run with inserts run on both vertical shuttle presses and standard horizontal machines.

The two parts seen in this picture could not have been injection molding without the process of gas assist being used. Nitrogen gas is forced in to the upper part to create an open tube that is not possible any other way while the handle has a .750 inch wall section without sink while still being structurally sound.